Epson AcuLaser C1100 - Panel Settings List

EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Control Panel 49
1.15.2 Panel Settings List
The printer settings are listed below.
Underlined value in the Setting value column are factory default settings.
Information Menu
Note *1: Only displayed when the network interface board is installed, and “Network Menu” -
“Network I/F=On”.
*2: Only displayed when a D4-compliant USB external device is connected, and “USB
Menu” - “USB I/F=On”.
*3: This item is for display only and cannot be modified.
Status Menu
This menu is displayed only when a warning occurs.
Tray Menu
Note *1: The default value depends on the controller configuration settings.
(For details, refer to
“Controller Configuration” (p.46).)
*2: Selectable when the lower feed unit is installed.
*3: Always A4 by default, irrespective of the controller configuration.
Printing Menu
Note *1: This item exists as the parameter, but not displayed on the panel.
*2: Paper size specified by ESCPAGE-S03 command is not differ among the each
destination, both size are available.
*3: The default value depends on the controller configuration settings.
Setting Setting values Status sheet
Status Sheet --- ---
Network Status Sheet*
1
--- ---
USB Extl/FstatusSht*
2
--- ---
C Toner*
3
EF to E******F {
M Toner*
3
EF to E******F {
Y Toner*
3
EF to E******F {
K Toner*
3
EF to E******F {
Photocondctr*
3
EF to E******F {
Total Pages*
3
0 to 99999999 {
Color Pages*
3
0 to 99999999 {
B/W Pages*
3
0 to 99999999 {
Setting Setting values Status sheet
MP Tray Size*
1
A4, A5, B5, LT, HLT, GLT, EXE, MON, C10,
DL, C5, C6, IB5
{
LC Size*
2
*
3
A4, LT, {
MP Type*
2
*
3
Plain, SemiThk, Letterhead, Recycled, Color,
Trnsprncy, Labels
{
LC Type*
2
Plain, SemiThk, Letterhead, Recycled, Color {
Setting Setting values Status sheet
Page Size*
1
*
2
*
3
A4, A5, B5, LT, HLT, GLT, EXE, MON, C10,
DL, C5, C6, IB5
---
Orientation*
1
Port, Land ---
Resolution*
1
300, 600 ---
RITech*
1
On, Off ---
Toner Save*
1
On, Off ---
Page Scale Off, 80% ---
Image Correct*
1
1, 2 ---
Top Offset*
1
-30.0 to 0.0 to 30.0mm ---
LeftOffset*
1
-30.0 to 0.0 to 30.0mm ---
T Offset B*
1
-30.0 to 0.0 to 30.0mm ---
L Offset B*
1
-30.0 to 0.0 to 30.0mm ---