Epson AcuLaser C1100 - Latch Dup R, Latch Dup L

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY DUPLEX 428
4.12.13 LATCH DUP R, LATCH DUP L
REMOVAL
1. Remove DUPLEX ASSY. (p.412)
2. Remove COVER-R DUP. (p.413)
3. Remove COVER-L DUP. (p.414)
4. Remove LINK-LATCH and LINK-BUTTON. (p.416)
5. Unclamp the clamp on BKT MOTOR DUP TRANS, and remove the harness.
6. Disconnect connector (P/J444) from PWBA DUP-L.
7. Remove the 4 screws (silver, with flange, tapping, 10mm) fastening BKT
MOTOR DUP TRANS to DUPLEX ASSY.
8. Remove BKT MOTOR DUP TRANS from DUPLEX ASSY together with PWBA
DUP-L and MOTOR ASSY DUP.
9. Remove SPRING LATCH from LATCH DUP R.
10. Remove the screw (silver, with flange, tapping, 10 mm) fastening LATCH DUP L
to DUPLEX ASSY.
11. Turn LATCH DUP R and LATCH DUP L, match the protrusions on LATCH
DUP R and LATCH DUP L with the notches of hole on DUPLEX ASSY, and
remove LATCH DUP R and LATCH DUP L.
Figure 4-128. Removal of LATCH DUP R and LATCH DUP L (1)
C A U T I O N
 When performing the following work, take care not to remove
DUPLEX ASSY and BKT MOTOR DUP TRANS too far as
they are connected by a harness.
 When performing the following work, take care not to drop or
lose gears, and other parts.
Leg_Sec03_128FB
5)
6)
7)
7)
7)
7)
8)