Epson AcuLaser M2000D - Page 156

EPSON AcuLaser M2000D/M2000DN/M2010D/M2010DN Revision B
ADJUSTMENT Adjustment 147
Confidential
7 Execute the update.
When the transfer is complete, “completed” window pops up. Click [OK].
“Completion” pop-up window will be displayed when the data transfer is
finished. Click on the [OK].
While receiving data, the Ready light blinks and the Paper, Toner, Memory
lights turn on.
8 Reboot the Printer.
After confirming that the Ready light turns on, turn the printer power off and
turn back on again.
After confirming that the Ready light blinks, turn the printer power off and turn
back on again.
9 Print the status sheet. Prints the status sheet. Prints the status sheet.
10
Check the version on the
status sheet.
Confirm that the program firmware version has been updated correctly by
comparing the status sheet with that printed in step 1. Refer to “ 1.21 Status
Sheet ” (p74)
Confirm that the program firmware version has been updated correctly by
comparing the status sheet with that printed in step 1. Refer to “ 1.21 Status
Sheet ” (p74)
Procedure RCC data format CRB data format