Epson Artisan 730 - Page 200

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Routing FFC/cables 200
Confidential
MAIN BOARD (REAR SIDE OF THE CARTRIDGE BOX)
(ARTISAN 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD)
Note * :See Fig. 4-196 for the connector positions on the Main Board.
Figure 4-202. Rear side of the Cartridge Box
(Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD)
MAIN BOARD (BEHIND CARTRIDGE BOX)
(ARTISAN 710/725/730/PX710W/TX710W/PX720WD/TX720WD/
PX730WD/TX730WD)
Note * :See Fig. 4-198 for the connector positions on the Main Board.
Figure 4-203. Routing to the FFC Holder
(Artisan 710/725/730/PX710W/TX710W/PX720WD/TX720WD/PX730WD/
TX730WD)
No. FFC/cable name CN No.
*
Remarks
1 CR Encoder FFC CN6
Ferrite core (x1)
(See Fig. 4-44)
2 Head FFC (x4) CN1,2,3,4 ---
3 CSIC FFC CN5 ---
CSIC FFC
Head FFC (x4):
Route them through the ribs (x4),
and secure them on the rear side
of the Cartridge Box with double-
sided tape (x2).
CR Encoder FFC:
Route this through the ribs (x4).
Fold line
Rib
Double-sided tape
No. FFC/cable name CN No.
*
Remarks
1 Panel FFC CN33 Ferrite core (x1)
2 CR Encoder FFC CN6 ---
3 Head FFC (x4) CN1,2,3,4 ---
4 CSIC FFC CN5 ---
Head FFC (x4)
Panel FFC
CSIC FFC
CR Encoder FFC
Put the Panel FFC only
through the ferrite core.
Fold line
Rib
Double-sided tape
Spacer:
Attach it to the Panel FFC with double-sided
tape, and secure it with the hooks (x2).
CR Encoder FFC & Head FFC (x4):
Route them through the ribs (x4),
and secure them with double-sided
tape (x2) behind the Cartridge Box.
Panel FFC:
Route it through the ribs
(x4), and the ferrite core.