Epson Artisan 730 - Page 201

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Routing FFC/cables 201
Confidential
STACKING THE HEAD FFC
(ARTISAN 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD)
Secure the Head FFCs (x4) and the CR Encoder FFC with double-sided tape, stack
them up in numeric order from inside shown in
Figure 4-204, and route them.
Note * :See Fig. 4-196 for the connector positions on the Main Board.
Figure 4-204. Stacking the Head FFC
(Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD)
STACKING THE HEAD FFC
(ARTISAN 710/725/730/PX710W/TX710W/PX720WD/TX720WD/
PX730WD/TX730WD)
Secure the Panel FFC, the Head FFCs (x4) and the CR Encoder FFC with double-sided
tape, stack them up in numeric order from inside shown in
Figure 4-204 and Figure
4-205, and route them.
Note * :See Fig. 4-198 for the connector positions on the Main Board.
Figure 4-205. Stacking the Head FFC
(Artisan 710/725/730/PX710W/TX710W/PX720WD/TX720WD/PX730WD/
TX730WD)
No. FFC/cable name CN No.
*
Remarks
1 CR Encoder FFC CN6
Ferrite core (x1)
(See Fig. 4-44)
2 Head FFC (x4) CN1,2,3,4 ---
Sheet Slider
Sheet Slider
Tube Guide Outer
Tube Guide Sub
Tube Guide Inner
Attach the Sheet Slider to the
Head FFC where the Ink Tube
touches the FFC.
Attach Clamp Tubes (x2) to the Tube
Guide Outer with double-sided tape.
Confirm that the CR Encoder is
attached to the Carriage Unit with
double-sided tape (x4).
Double-sided tape
1
2
3
4
5
6
CR Encoder FFC
Clamp Tube
90 mm
110 mm
Head FFC
Head FFC
No. FFC/cable name CN No.
*
Remarks
1 Panel FFC CN33
Ferrite core (x1)
(See Fig. 4-203)
2 CR Encoder FFC CN6 ---
3 Head FFC (x4) CN1,2,3,4 ---
Panel FFC
See Fig. 4-204 for
stacking the Head
FFCs (x4) and CR
Encoder FFC.
Secure this section
to the Head FFC.
Secure this section to the Panel Unit
and Front Frame. (See Fig. 4-166.)
Double-sided tape