106 UMFLUXUS_G6V4-2EN, 2011-03-29
FLUXUS G60x 14 Data Logger and Transmission of Data
14.2.7 Offline Transmission of Data with the Program FluxData
The measurement data in the data logger are transmitted to a PC via the serial interface
RS232 with the FLEXIM program FluxData.
Settings in the transmitter
Further settings in the transmitter are not necessary.
This error message will be displayed if no measured va-
lues are stored. Press ENTER.
This message will be displayed if the measuring signal is
sufficient.
The progress of the transmission of data is displayed by a
bar graph.
This error message will be displayed if an error has oc-
curred during the serial transmission. Press ENTER.
Check the connections and make sure that the PC is ready
to receive data.
Press BRK to select the main menu.
NO VALUES !
Print Meas.Val.
Send Header 01
................
■ ■ ■ ■ ■ ■
................
SERIAL ERROR !
Print Meas.Val.
par mea opt >sf<
Special Funct.
To Next Page
Loading...
Need help?
General
