Versiv Series Cabling Certification Product Family
Technical Reference Handbook
80
TOOLS: The TOOLS menu lets you set the reference, see the
status of the tester, and set user preferences such as the
language and the display brightness.
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
SYNC: To upload results to LinkWare Live, tap SYNC. See Chapter
18.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the tests in the project that are completed.
The tester uses the number of available IDs to calculate this
percentage. See Figure 199 on page 528. % Tested does not
show if your project contains only a Next ID list. See “To Make ID
Sets with International Characters” on page 550 for more
information about the Next ID list.
The type of module attached to the tester.
This icon shows when the tester’s link interface adapter is
connected to the adapter on a remote and the remote is turned
on.
DSX-5000 only: The arrows on the remote connection icon
are orange when the main and remote use long-range
communication mode. See “Long-Range Communication Mode
(DSX-5000)” on page 158.
The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 566.
This icon shows when the talk function is on. See “How to
Use the Talk Function” on page 157.
To Next Page
Loading...
