Chapter 3: Certify Twisted Pair Cabling
The DSX CableAnalyzer Home Screen
79
Shows a summary of the test results in the project:
The number of tests that passed.
The number of tests that failed.
The number of results from tests on twisted pair cable that
have PASS* results. PASS* results have measurements within
the range of accuracy uncertainty for the tester. See “PASS*/
FAIL* Results” on page 98.
The test setup panel shows the settings the tester will use when
you tap TEST or press . To change these settings, tap the
panel.
Note
You can set up tests for any module that the tester
can use, even when no module is attached.
Icons show the status of the Store Plot Data and AC Wire Map
settings. See Table 3 on page 86.
Next ID: The Next ID panel shows the ID that the tester gives to
the next test results you save.
Tap Next ID to do these tasks:
Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
Turn Auto Save on or off.
Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names. For each operator you
can also enter the email address that the operator will use as an
ID to sign in to LinkWare Live.
To Next Page
Loading...
