Foundry Networks Switch and Router - Displaying General Ospf Configuration Information; Displaying Ospf Information

Configuring OSPF
December 2000 17 - 41
7. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
Displaying OSPF Information
You can use CLI commands and Web management options to display the following OSPF information:
• Trap, area, and interface information – see “Displaying General OSPF Configuration Information” on page 17-
41.
• CPU utilization statistics – see “Displaying CPU Utilization Statistics” on page 17-42.
• Area information – see “Displaying OSPF Area Information” on page 17-43.
• Neighbor information – see “Displaying OSPF Neighbor Information” on page 17-44.
• Interface information – see “Displaying OSPF Interface Information” on page 17-46.
• Route information – see “Displaying OSPF Route Information” on page 17-46.
• External link state information – see “Displaying OSPF External Link State Information” on page 17-48.
• Link state information – see “Displaying OSPF Link State Information” on page 17-49.
• Virtual Neighbor information – see “Displaying OSPF Virtual Neighbor Information” on page 17-50.
• Virtual Link information – see “Displaying OSPF Virtual Link Information” on page 17-50.
• ABR and ASBR information – see “Displaying OSPF ABR and ASBR Information” on page 17-51.
• Trap state information – see “Displaying OSPF Trap Status” on page 17-51.
Displaying General OSPF Configuration Information
To display general OSPF configuration information, enter the following command at any CLI level:
BigIron> show ip ospf config
Router OSPF: Enabled
Redistribution: Disabled
Default OSPF Metric: 10
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 25000
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 207.95.11.128
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Enabled
Virtual Interface Retransmit Packet Trap: Enabled