Foundry Networks Switch and Router User Manual

Configuring OSPF
December 2000 17 - 43
RIP 0.00 0.00 0.00 0.00 0
STP 0.00 0.00 0.00 0.00 0
VRRP 0.00 0.00 0.00 0.00 0
To display utilization statistics for a specific number of seconds, enter a command such as the following:
BigIron# show process cpu 1
Process Name Sec(%) Time(ms)
ARP 0.00 0
BGP 0.00 0
ICMP 0.01 1
IP 0.00 0
OSPF 0.00 0
RIP 0.00 0
STP 0.00 0
VRRP 0.00 0
Syntax: show process cpu [<num>]
The <num> parameter specifies the number of seconds and can be from 1 – 900. If you use this parameter, the
command lists the usage statistics only for the specified number of seconds. If you do not use this parameter, the
command lists the usage statistics for the previous one-second, one-minute, five-minute, and fifteen-minute
intervals.
USING THE WEB MANAGEMENT INTERFACE
You cannot display this information using the Web management interface.
Displaying OSPF Area Information
To display global OSPF area information for the router, use one of the following methods.
USING THE CLI
To display OSPF area information, enter the following command at any CLI level:
BigIron> show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 192.147.60.0 normal 0 1 0 0 1 0000fee6
3 192.147.80.0 stub 1 1 0 0 2 000181cd
Syntax: show ip ospf area [<area-id>] | [<num>]
The <area-id> parameter shows information for the specified area.
The <num> parameter displays the entry that corresponds to the entry number you enter. The entry number
identifies the entry’s position in the area table.
This display shows the following information.
Table 17.2: CLI Display of OSPF Area Information
This Field... Displays...
Indx The row number of the entry in the router’s OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
• nssa
• normal
• stub

Foundry Networks Switch and Router Specifications

General

Brand	Foundry Networks
Model	Switch and Router
Category	Switch
Language	English