Foundry Networks Switch and Router User Manual

Updating Software Images and Configuration Files
December 2000 7 - 11
BigIron# reload after 01:12:00 secondary
Syntax: reload after <dd:hh:mm> [primary | secondary]
<dd:hh:mm> is the number of days, hours, and minutes.
primary | secondary specifies whether the reload is to occur from the primary code flash module or the
secondary code flash module.
USING THE WEB MANAGEMENT INTERFACE
You cannot schedule a system reload using the Web management interface.
Displaying the Amount of Time Remaining Before a Scheduled Reload
To display how much time is remaining before a scheduled system reload takes place, use one of the following
methods.
USING THE CLI
To display how much time is remaining before a scheduled system reload, enter the following command from any
level of the CLI:
BigIron# show reload
USING THE WEB MANAGEMENT INTERFACE
You cannot display information about a scheduled reload using the Web management interface.
Canceling a Scheduled Reload
To cancel a scheduled reload, use one of the following methods.
USING THE CLI
To cancel a scheduled system reload using the CLI, enter the following command at the global CONFIG level:
BigIron# reload cancel
USING THE WEB MANAGEMENT INTERFACE
You cannot cancel a scheduled reload using the Web management interface.

Foundry Networks Switch and Router Specifications

General

Brand	Foundry Networks
Model	Switch and Router
Category	Switch
Language	English