Foundry Networks Switch and Router User Manual

Configuring OSPF
December 2000 17 - 51
Displaying OSPF ABR and ASBR Information
To display OSPF ABR and ASBR information for the router, use one of the following methods.
USING THE CLI
To display OSPF ABR and ASBR information, enter the following command at any CLI level:
BigIron> show ip ospf border-routers
Syntax: show ip ospf border-routers [<ip-addr>]
The <ip-addr> parameter displays the ABR and ASBR entries for the specified IP address.
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration panel is displayed.
2. Click on the plus sign next to Monitor in the tree view to expand the list of monitoring options.
3. Click on the plus sign next to OSPF in the tree view to expand the list of OSPF option links.
4. Click on the ABR ASBR Routers
link.
Displaying OSPF Trap Status
To display the state (enabled or disabled) of the OSPF traps, use one of the following methods.
All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, see “Modify
OSPF Traps Generated” on page 17-37.
USING THE CLI
To display the state of each OSPF trap, enter the following command at any CLI level:
BigIron> show ip ospf trap
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Enabled
Virtual Interface Retransmit Packet Trap: Enabled
Originate LSA Trap: Enabled
Originate MaxAge LSA Trap: Enabled
Link State Database Overflow Trap: Enabled
Link State Database Approaching Overflow Trap: Enabled
Syntax: show ip ospf trap
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration panel is displayed.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to OSPF in the tree view to expand the list of OSPF option links.
4. Click on the Trap
link to display the OSPF Trap panel.

Foundry Networks Switch and Router Specifications

General

Brand	Foundry Networks
Model	Switch and Router
Category	Switch
Language	English