Foundry Switch and Router Installation and Configuration Guide
2 - 20 December 2000
Figure 2.8 Installing a Chassis device in a rack mount
Rack Mount Installation – Stackable Devices
NOTE: You need a #2 Phillips-head screwdriver for installation.
1. Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting brackets and
mounting screws.
2. Attach the mounting brackets to the sides of the device as illustrated in Figure 2.9.
3. Attach the device in the rack as illustrated in Figure 2.9.
4. Proceed to “Testing Connectivity” on page 2-26.
NOTE: If you are installing a Chassis device, see “Installing or Removing Optional Modules (Chassis Devices
Only)” on page 2-4 and “Installing or Removing Redundant Power Supplies (Chassis Devices Only)” on page 2-6
before proceeding to “Testing Connectivity” on page 2-26.
To Next Page
Loading...
