Fujitsu Eternus web GUI - Page 119

Chapter 6 RAID Group Management
6.2 Functions in the Action Area for RAID Group
ETERNUS Web GUI User’s Guide
119
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
■ Automatically selecting drives to create RAID groups
The procedure to create a RAID group is as follows:
Procedure
1 Click [Create] in [Action].
2 Select "Automatic" for "Create Mode".
3 Specify the RAID group detailed information, and click the [Create] button.
• Name
Input a RAID group name that is to be created.
An existing RAID group name cannot be used.
The following input conditions apply:
- 1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
• Number of RAID Group
Input the number of RAID groups that is to be created.
When creating multiple RAID groups at a time, the new RAID groups are named
automatically. Refer to "Appendix C Naming Convention of Volumes" (page 617)
for
details.
• Disk Type
Select the type of drive that configures a RAID group from the list box.
- Online
- Nearline
- SSD
• RAID Type
Select the type of RAID group that is to be created from the list box.
- High Performance (RAID1+0)
- High Capacity (RAID5)
- High Reliability (RAID6)
- Reliability (RAID5+0)
- Mirroring (RAID1)
- Striping (RAID0)
• RAID Group Capacity
Enter the RAID group capacity that is to be created and select the units of capacity.
A RAID group is automatically created with a capacity of the entered value or higher.
The following input conditions apply:
- Numeric characters
- TB/GB