Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
329
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
4 Click the [OK] button.
→ Modification of the SAS host group starts.
5 Click the [Done] button to return to the [Host Group] screen.
An error screen appears in the following conditions:
• When the "Host Group Name" does not satisfy the input
conditions
• When the "Host Group Name" has not been specified
An error screen appears in the following conditions:
• When the "Host Group Name" matches with an existing host
group name (Host group names cannot overlap with any other
host group names, irrespective of the interface types.)
• When the total number of hosts has exceeded the maximum
number for the device
• When no hosts are registered in a host group, or when nine or
more hosts are registered in a host group
• When the specified host has already been registered in another
host group
• The specified SAS address has already been registered in the
ETERNUS DX Disk storage system
• When the several SAS hosts with the same SAS addresses have
been registered
• When the specified host response does not exist in the
ETERNUS DX Disk storage system
To Next Page
Loading...