Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
341
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
3 Click the [OK] button.
→ Registration of the FC port group starts.
4 Click the [Done] button to return to the [Port Group] screen.
9.2.3.2 Create iSCSI Port Group
This function creates a new iSCSI port group, and registers the port to be a member.
An iSCSI port group is a group of iSCSI-CA type ports that are connected to the specified host
group. This function configures the host affinity setting for each iSCSI port group.
• The maximum number of port groups per device is 128, irrespective of the CA types.
• The maximum number of ports per port group is 8.
• A port can be a member of several port groups.
An error screen appears in the following conditions:
• When the port group name does not satisfy the input conditions
• When the port group name has not been entered
An error screen appears in the following conditions:
• When the port group name overlaps with an existing port group
name (port group names cannot overlap with any other port group
names, irrespective of the CA types.)
• When the total number of ports has exceeded the maximum
number for the ETERNUS DX Disk storage system
• When no ports are registered in a port group, or when nine or
more ports are registered in a port group
• When the specified port does not exist in the ETERNUS DX Disk
storage system
• When the port mode of the selected port is other than "FC"
• When there are ports of which affinity mode is enabled (On) and
disabled (Off) existing together
To Next Page
Loading...