Fujitsu Eternus web GUI - Page 340

Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
340
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
The procedure to create an FC port group is as follows:
Procedure
1 Click [Create FC Port Group] in [Action].
2 Specify the name of the port group to be created, select all the ports to be
registered in the port group, and click the [Create] button.
• Name
Specify the port group name.
An existing port group name cannot be specified.
The following input conditions apply:
- 1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
• Checkbox to select a port
Select the checkbox of the FC port to be registered in a FC port group.
→ A confirmation screen appears.
• To change the settings of a port groups, refer to "9.2.3.6 Modify Port
Group" (page 350).
• To add a port to an existing port group, refer to "9.2.3.6 Modify Port
Group" (page 350).
• To change the port mode from "RA" to "CA", refer to "9.2.3.11 Modify
Port Mode" (page 373).
• When a port that has the affinity mode enabled (On) is
selected, ports that have the affinity mode disabled (Off)
cannot be selected.
• When a port that has the affinity mode disabled (Off) is
selected, ports that have the affinity mode enabled (On)
cannot be selected.
• Up to eight ports can be selected.