Fujitsu Eternus web GUI - Page 428

Chapter 10 Component Management
10.1 Component Status
ETERNUS Web GUI User’s Guide
428
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
• Status Code
The drive status code is displayed.
• Error Code
The drive error code is displayed.
• Capacity
The capacity of the drive is displayed.
• Type
The drive type is displayed.
- For 2.5-inch SAS disks: 2.5" Online
- For 3.5-inch SAS disks: 3.5" Online
- For 3.5-inch Nearline SAS disks: 3.5" Nearline
- For 2.5-inch SSD: 2.5" SSD
- For 3.5-inch SSD: 3.5" SSD
• Speed
The drive speed is displayed. For SSD, "0 rpm" is displayed.
- 15000 rpm
- 10000 rpm
- 7200 rpm
- 0 rpm
• Usage
The usage of the drive is displayed.
- Disk
- Data
- Unused
- System
- Global Hot Spare
- Dedicated Hot Spare
• RAID Group
If the drive is registered in the RAID group, the RAID group number and the RAID group
name to which the drive belongs is displayed.
By clicking this item, the [RAID Group] screen is displayed.
The RAID group name cannot be clicked when logged on via a Slave CM.
• Motor Status
The drive motor status is displayed.
- "Active" status is displayed during operation of the device
- "In the Boot Process" status is displayed during operation of the device
- "Idle" status is displayed when the device is not running
- "In the Stop Process" is displayed when the device is in the process of stopping
• Rebuild/Copyback Progress
When rebuild or copyback is being performed, the progress ratio is displayed.
When rebuild or copyback is being performed, the progress ratio is displayed.
• Vendor ID
The drive manufacturer name is displayed.