Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
551
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
● Setting based on Severity
Select whether to notify of an event by levels. Checkboxes are displayed for selectable
notification methods.
• All Error Events
Select whether to notify when an error level event occurs. When notifying, select the
notification method.
• All Warning Events
Select whether to notify when a warning level event occurs. When notifying, select the
notification method.
• All Informational Events
Select whether to notify when a informational level event occurs. When notifying, select
the notification method.
• Individual Settings within Severity Level
"Yes" is displayed when the target notification method ("Host Sense Key Code
Qualifier", "SNMP Trap", "E-Mail", "syslog" or "REMCS") is specified for any event in
"Error Severity Level", "Warning Level", or "Informational Level", if not, "No" is
displayed.
● Error Severity Level
Select whether to notify of the error event for each event type.
• Parts Error
Select whether to notify when a failure occurs in a component other than the drive.
When notifying, select the notification method.
• Disk Error
Select whether to notify when a drive failure occurs for each condition shown below.
When notifying, select the notification method.
- Any Time
Notifies always when a drive failure occurs.
- when HS<0
Notifies only when a drive failure occurs while available hot spare disk is "Less than
0" (*1).
*1: When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
• Temperature Error
Select whether to notify when a temperature error status is detected by the sensor.
When notifying, select the notification method.
• End of battery life
Select whether to notify when a battery expires. When notifying, select the notification
method.
"Time limit of the buttery cuts" notification is available only for ETERNUS DX410 S2/
DX440 S2.
To Next Page
Loading...