Fujitsu Eternus web GUI - Page 576

Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
576
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
11.2.9.1 Modify Storage Name
This function registers the name, administrator, and the installation site of the ETERNUS DX
Disk storage system.
Information registered in this screen is used for the following functions and screens:
• Network management using SNMP
• Storage system name displayed in the login screen and the operation screens
The procedure to change the device name is as follows:
Procedure
1 Click [Modify Storage Name].
2 Specify the parameters, and click the [Set] button.
• Name
Specify the storage system name (required).
The following input conditions apply:
- 1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Spaces
• Installation Location
Specify the installation location of the ETERNUS DX Disk storage system.
The following input conditions apply:
- 1 - 50 alphanumeric characters and symbols (except ", (comma)" and "?")
- Spaces
• Administrator
Specify the administrator information (the administrator name, contact information, etc)
of the ETERNUS DX Disk storage system.
The following input conditions apply:
- 1 - 50 alphanumeric characters and symbols (except ", (comma)" and "?")
- Spaces
• Description
Specify the description of the ETERNUS DX Disk storage system.
The following input conditions apply:
- 1 - 50 alphanumeric characters and symbols (except ", (comma)" and "?")
- Spaces
Once the storage system name has been specified, it cannot be deleted (it
can be changed).