12-10 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
■ Set up the CPU operational mode on the domain.
Refer to Chapter 2, “Setting Up XSCF,” in the SPARC Enterprise
M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s Guide for information
about these settings.
16. Use the setdomainmode(8) command to disable the autoboot function of the
domain.
Refer to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
User’s Guide and the setdomainmode(8) man page for more information.
17. Power on the new domain.
18. Confirm that the target domain has been correctly started.
19. Confirm that no error has occurred.
20. Install a version of the Oracle Solaris OS that supports SPARC64 VII/SPARC64
VII+ processors.
Note – Supported firmware and Oracle Solaris OS will vary based on the processor
type. For details, see the latest version of the Product Notes (for XCP version 1100 or
later) for your server.
For information about network-based installations, refer to Solaris 10 8/07
Installation Guide: Network-Based Installations (part 820-0177).
21. Use the setdomainmode(8) command to enable the autoboot function of the
domain.
The autoboot function is applied by a domain reboot. For more information, refer
to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s
Guidee and the setdomainmode(8) man page.
XSCF> poweron -d domain_id
XSCF> showlogs power
XSCF> showlogs error -v
XSCF> showstatus
To Next Page
Loading...
Need help?
General