13-22 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
17. Power on all the target domain.
18. Confirm that the target domain has been properly started.
19. Use the showlogs error -v command and the showstatus(8) command, to
confirm that no errors occurred.
If you found any errors on the hardware, contact a certified service engineer.
XSCF> poweron -a
XSCF> showlogs power
XSCF> showlogs error -v
XSCF> showstatus
To Next Page
Loading...
Need help?
General