Any hardware errors detected on power up will appear on the operator display (CRT or
LCD). Note that the Model VF50 two-line alphanumeric display does not display error
messages.
6.1.4 Powering OFF
1. Lift the plastic switch cover.
2. Press the ON/OFF switch.
90000291 Rev 3.0 6-3
TeamPoS 2000 MAINTENANCE MANUAL
Note: Depending on BIOS setup, a momentary depression of the switch may signal the
application to shut the unit down, which could take a few minutes. If power is
not immediately turned off, either wait for the application to shut the unit down,
or keep the switch depressed for approximately 4 seconds. For proper shutdown
procedures, see the application software documentation.
Note: Some peripherals, such as scanners and scales, may be separately powered.
Check the peripheral manuals for instructions for these peripherals.
To Next Page
Loading...