Fujitsu TeamPoS 2000 - Chapter 9 BIOS SETUP PROCEDURES - a Motherboard; Opening CMOS Setup Screen - a Motherboard; CMOS Settings - a Motherboard; Main Menu - a Motherboard

Chapter 9 BIOS SETUP PROCEDURES - A Motherboard
Follow the procedures shown below to set the PC board after replacement.
9.1 Opening CMOS Setup Screen - A Motherboard
Turn ON power and press the DEL key while a “PRESS DEL TO ENTER SETUP”
message is displayed in the lower part of the CRT or LCD. (See section 7.1.1 for power
on procedures.)
9.1.1 CMOS Settings - A Motherboard
In most cases, the CMOS default settings are adequate and do not require changing.
Follow the instructions on the screen to select STANDARD CMOS SETUP. To change
the time and date follow the instructions on the screen. Run LOAD BIOS DEFAULTS
first and then LOAD SETUP DEFAULTS. Exit, saving settings. Changing other
default settings can adversely effect the operation of the unit.
9.1.2 Main Menu - A Motherboard
Factory Default Settings
ROM PCI/ISA BIOS (XXXXXXXX)
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
STANDARD CMOS SETUP CLOCK AND SENSOR
BIOS FEATURES SETUP INTEGRATED PERIPHERALS
CHIPSET FEATURES SETUP SUPERVISOR PASSWORD
POWER MANAGEMENT SETUP USER PASSWORD
PNP/PCI CONFIGURAITON IDE HDD AUTO DETECTION
LOAD BIOS DEFAULTS SAVE & EXIT SETUP
LOAD SETUP DEFAULTS EXIT WITHOUT SAVING
ESC : Quit
¯® : Select Item
F10 : Save & Exit Setup (Shift) F2 : Change Color
90000291 Rev 3.0 9-1
TeamPoS 2000 MAINTENANCE MANUAL