9.1.6 Power Management Setup - A Motherboard
Factory Default Settings
ROM PCI /ISA BIOS (XXXXXXXX)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
ACPI Function (see note) : Disabled IRQ 8 Break Suspend : Disabled
Power Management : User Define ** Reload Global Timer Events**
PM Control by APM : No IRQ [3-7, 9-15], NMI : Disabled
Video Off Method : DPMS Primary IDE 0 : Disabled
Video Off After : NA Primary IDE 1 : Disabled
MODEM Use IRQ : NA Secondary IDE 0 : Disabled
Doze Mode : Disabled Secondary IDE 1 : Disabled
Standby Mode : Disabled Floppy Disk : Disabled
Suspend Mode : Disabled Serial Port : Disabled
HDD Power Down : Disabled Parallel Port : Disabled
Throttle Duty Cycle : 50.0%
PCI/VGA Act-Monitor : Disabled
Soft-Off by PWR-BTTN : Delay 4 sec.
CPUFAN Off In Suspend : Disabled
PowerOn by Ring : Disabled
Power On on PCI card : Disabled
Resume by alarm : Disabled
Wake Up On LAN : Enabled
Esc: Quit ¯®¬ : Select
F1 : Help PU/PD/+/- : Modify
F5 : Old Valuess (Shift) F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
90000291 Rev 3.0 9-5
TeamPoS 2000 MAINTENANCE MANUAL
Note: When a 133PQ keyboard is used in a Windows 2000 or XP environment, ACPI
function must be set to "Enabled" or the MSR will not work. If the operating
system is configured with ACPI enabled and BIOS is set to ACPI disabled, the
system will not boot up.
To Next Page
Loading...