Chapter 8 BIOS Setup Procedures - M Motherboard
Follow the procedures shown below to set the PC board after replacement
8.1 Opening CMOS Setup Screen
Turn ON power and press the DEL key while a "PRESS DEL TO ENTER SETUP"
message is displayed in the lower part of the CRT or LCD. (See section 7.1.1 for power
on procedures.
A message will appear asking you to enter a password. Hit the "Enter" key and continue
8.1.1 CMOS Settings
In most cases, the CMOS default settings are adequate and do not require changing.
Follow the instructions on the screen to select STANDARD CMOS SETUP. To change
the time and date follow the instructions on the screen. Run LOAD OPTIMAL
DEFAULTS located under the "Exit" tab. Exit, saving settings. Changing other default
settings can adversely effect the operation of the unit.
90000291 Rev 3.0 8-1
TeamPoS 2000 MAINTENANCE MANUAL
To Next Page
Loading...