Fujitsu TeamPoS 2000 - A Motherboard Settings

7.4 A Motherboard Settings
No. Pin
Name
Meaning Default
Settings
1
JP0601 CPU frequency multiplier - Not Used 1-2 Short
3-4 Open
5-6 Open
7-8 Open
2
JP0301 See 1st note below.
Select either Pentium III or Celeron. (Voltage setting)
Jumper 1-2: Pentium III and 566 MHz Celeron
(Coppermine core)
Jumper 2-3: Celeron 433 (Mendocino core)
Depends on
CPU
3 JP0302
JP0303
Select either Coppermine or Mendocino CPU
SHORT: Pentium III & 566 MHz Celeron (Coppermine core)
OPEN: 433 MHz Celeron (Mendocino Core)
SHORT: Pentium III & 566 MHz Celeron (Coppermine core)
OPEN: 433 MHz Celeron (Mendocino Core)
Depends on
CPU
4
JP0701 Deleting the CMOS RAM password
1-2: Normal
2-3: Password deleted
1-2
5
JP1501 Keyboard/mouse power sources
1-2: Normal 5 V system
2-3: Standby 5 V system (Default Test Only)
1-2
6
JP2402
See 2nd note below.
DC output mode at AC input (see note 2 that follows)
5-6, 2-3: POS mode
4-5, 2-3: General PC mode
5-6, 1-2: AC_ON mode (not used)
5-6, 2-3
7-10 Rev 3.0 90000291
TeamPoS 2000 MAINTENANCE MANUAL
Note: Coppermine is also referred to as 0.18mm technology. The 600 and 800 MHz
and 1GHz Pentium III and 566MHz Celeron incorporate Coppermine technology.
Mendocino is also referred to as 0.25mm technology. The 433MHz Celeron
incorporates Mendocino technology.
Note: When power is OFF and then turned ON:
1. POS mode boots up automatically.
2. General PC Mode stays OFF until turned ON by power switch
3. AC-ON mode is not used.