MEMORY ADDRESS ERROR AT…
Indicates a memory address error at a specific location.
MEMORY PARITY ERROR AT…
Indicates a memory parity error at a specific location.
MEMORY VERIFY ERROR AT…
Indicates an error verifying a value already written to memory.
OFFENDING ADDRESS NOT FOUND
This message is used in conjunction with the I/O CHANNEL CHECK and RAM
PARITY ERROR messages when the segment that has caused the problem cannot be
isolated.
OFFENDING SEGMENT:
This message is used in conjunction with the I/O CHANNEL CHECK and RAM
PARITY ERROR messages when the segment that has caused the problem has been
isolated.
PRESS A KEY TO REBOOT
This will be displayed at the bottom screen when an error occurs that requires you to
reboot. Press any key and the system will reboot.
PRESS F1 TO DISABLE NMI, F2 TO REBOOT
When BIOS detects a Non-Maskable Interrupt condition during boot, this will allow you
to disable the NMI and continue to boot, or you can reboot the system with the NMI
enabled.
RAM PARITY ERROR - CHECKING FOR SEGMENT ¼
Indicates a parity error in random access memory.
SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT ¼
Indicates the present boot attempt has been aborted and the system must be rebooted.
Press and hold down the CTRL and ALT keys and press DEL.
FLOPPY DISK (S) fail (80)
Unable to reset floppy subsystem.
FLOPPY DISK (S) fail (40)
Floppy Type mismatches.
9-12 Rev 3.0 90000291
TeamPoS 2000 MAINTENANCE MANUAL
To Next Page
Loading...