GE LOGIQ Totus

GE HealthCare CONFIDENTIAL
Direction 5936427, Rev. 1 LOGIQ Totus Basic Service Manual
3 - 24 Section 3-5 - Completing the Setup
3-5-11 Groups
To use groups:
You can use predefined groups or create new groups. Assign groups to a user from Users and under
Group Memberships.
1.) Navigate to Utility > Admin > Groups.
2.) To use a pre-defined group:
a.) Under Group List, select from the list of groups with pre-determined access is available to
select for each new user.
b.) To view access rights for these groups, highlight a group and then, under Group Rights, view
the access rights.
3.) To create a new group and assign access rights:
a.) Select Add.
b.) Under Name and Description, type in the name and a description.
c.) Under Group Rights, select the boxes according to the users access needs.
d.) Select Exit and then select Admin before trying to assign new groups to a user.
NOTE: Admin has full system access rights.
Figure 3-13 Groups Window