GE HealthCare CONFIDENTIAL
Direction 5936427, Rev. 1 LOGIQ Totus Basic Service Manual
Chapter 1 Introduction 1 - 9
1-2-4-2 Overview
The LOGIQ Totus is a high performance digital ultrasound imaging system with total data management.
The fully digital architecture of the LOGIQ Totus allows optimal usage of all scanning modes and probe
types throughout the full spectrum of operating frequencies.
The LOGIQ Totus is a digital beamforming Ultrasound system. The Ultrasound signal flows from the
probe through the Ultrasound system where it is processed and finally displayed as a diagnostic image
on the monitor. Images and patient data can be sent to peripheral devices to be stored, printed, or
displayed.
System configuration is stored on the internal drive.
All necessary software is loaded from the internal drive on power up.
For more information on:
• Installed software versions, "Software Status" on page 7-18
• Installed hardware, Section 7-3 "Service Desktop" on page 7-10
• Connected probes, Section 7-3 "Service Desktop" on page 7-10
• Compatible software, hardware, peripherals, and probes, "Software" on page 9-23
1-2-4-3 FRUs for the ultrasound system
Refer to Chapter 9 in this manual.
1-2-4-4 Purpose of the user manual
The user manual should be fully read and understood before operating the LOGIQ Totus.
The online versions of the user manual is available through the Online Help function on the LOGIQ
Totus’s operator panel.
User manual documentation is provided through electronic Instructions For Use (eIFU).
To Next Page
Loading...
Need help?
General
