GE LOGIQ Totus

GE HealthCare CONFIDENTIAL
Direction 5936427, Rev. 1 LOGIQ Totus Basic Service Manual
3 - 38 Section 3-6 - Configuring the LOGIQ Totus
3-6-7 Network printers
You can add a network printer when logged on to the system as an administrator.
NOTE: It is solely the customer’s responsibility to determine printer and network settings and
configuration to enable and ensure the specific network printer usage and functionality.
To add a network printer, navigate to Utility > System > Peripherals, and then under Network Printer,
select Add Network Printer.
NOTE: Network printer is not available through Connection Manager.
Refer to “Network Printer” in the Basic User Manual (appropriate version) for more information. See
Section 1-4 "Labels/Icons on the system" on page 1-19 for a list of the available user documentation.
Technical details:
• The only supported driver for the network printer is Microsoft Enhanced Point and Print
Compatibility driver.
Non-validated, non-approved drivers should not be installed on the system.
• Adding a network printer requires the user is logged in with Admin group rights.
• You cannot use the same IP address for two printer names.
• Adding a network printer logs an event to both the main log and the audit log.