GE HealthCare CONFIDENTIAL
Direction 5936427, Rev. 1 LOGIQ Totus Basic Service Manual
7 - 8 Section 7-2 - Gathering Troubleshooting Data
7-2-5 Capturing network logs to use for troubleshooting
Use the Network Capture utility to capture network logs. Once the logs are captured and extracted from
the LOGIQ Totus, use Microsoft Message Analyzer to convert the output, and then Wireshark (or some
other network sniffer) to analyze it.
To troubleshoot network capture logs:
1.) On the LOGIQ Totus, run the Network Capture utility to generate .etl and .cab files for analysis.
For more information "Network Capture" on page 7-34.
2.) Locate the .etl file at D:\Service.
3.) Transfer these files to a laptop.
4.) On the laptop, download Microsoft Message Analyzer (if not already done).
5.) In Microsoft Message Analyzer, open the .etl file.
If the DICOM connection is encrypted, you will not be able to the contents of the packets. Microsoft
Message Analyzer does not have a plug-in to decode DICOM packets.
To Next Page
Loading...
Need help?
General
