GE HealthCare CONFIDENTIAL
DIRECTION 5936427, REV. 1 LOGIQ TOTUS Basic Service Manual
8 - 18 Section 8-4 - Loading / Reloading / Upgrading the Software
9.
After boot up, in Operator, enter ADM.
In Password, leave this field empty.
NOTE: No password is required. Do not create any
password at this time.
Select OK.
10.
When prompted with Default Security Level, select Skip
for Now for the security level, and then select Apply
Change.
NOTE: If you select the Lowest security level and then
continue with installation and testing. After the update is
complete, you can transfer the LOGIQ Totus to the Site
Administrator who can reset the security level for the
site. The security level can be reset through Utility >
Admin > Logon.
Table 8-6 Load Base Image and Application Software- full load(Continued)
Step Corresponding Graphic
To Next Page
Loading...
