GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
7-32 Section 7-9 - Error Messages
incorrect VersionByte, xx of xx cycles OK contact technical support
iPWCW_CloseProcessing in
RT_PWorCWFilterBlock::execute() returned error code xx !!
restart the system
iPWCW_InitializeProcessing in
RT_PWorCWFilterBlock::execute() returned error code xx !!
restart the system
iSetVideoSource(eVideoExtern) function fails restart the system
iSetVideoSource(eVideoIntern) function fails reboot the system
iSetVideoSource(eVideoIntern) function fails the system will restart itself by pressing OK
LineFilt Out Of Range press ok and save this user-setting once again
LP_KoefBlock: SamplePRF too big restart the system
M_Gain Out Of Range press ok and save this user-setting once again
M_Reject Out Of Range press ok and save this user-setting once again
MC Ensemble Out Of Range press ok and save this user-setting once again
MC_Balance Out Of Range press ok and save this user-setting once again
MC_BaseLinePos Out Of Range press ok and save this user-setting once again
MC_Dynamic Out Of Range press ok and save this user-setting once again
MC_FallSmooth Out Of Range press ok and save this user-setting once again
MC_Gain Out Of Range press ok and save this user-setting once again
MC_RiseSmooth Out Of Range press ok and save this user-setting once again
MCShotBuffer : not enough memory reserved restart the system
M-DynContrast Out Of Range+ press ok and save this user-setting once again
Memory access violation restart the system
memory allocation error restart the system
missing BCMCPW_TxFocusData restart the system
missing BM_TxFocusData restart the system
missing CW_TxFocusData restart the system
missing ProbeAcousticUnit, wrong ProbeAcousticUnitID. restart the system
missing ProbeGeneral data - wrong ProbeID restart the system
missing ProbeScanFunc - wrong ProbeScanFuncID restart the system
MMC Archive::not implemented restart the system
MotCtrl (DSP 6712): unknown or not (at the moment ?)
supported 4D probe
restart the system
MotCtrl RS232 communication timeout
System will restart on OK. If problem persists please
contact the technical support.
Error Messages Actions
To Next Page
Loading...
