GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
8-8 Section 8-2 - System Software - Installation/Upgrade Procedure
8-2-1-5 System Software - Installation Procedure (FMI from DVD) (cont’d)
In this case, connect the Power supply to charge the battery, afterwards try again.
NOTE: To check capacity of the battery, move the cursor over the Battery Icon in the status area
(see: Figure 5-11 on page 5-31).
10.)Verify that only the DVD drive is connected to the system, then click OK
(Figure 8-6 below).
11.)To start update procedure click YES
(Figure 8-7 below).
12.)The system saves Full Backup in silent mode on R:, then it reboots into LINUX.
13.)A silent “Rollback” image from C:\ is stored on R:\.
After executing all LINUX commands, the system reboots again.
Figure 8-5 battery less charged or Power supply is disconnected
Figure 8-6 Verify that USB devices are disconnected, then click OK
Figure 8-7 Yes - start update procedure
To Next Page
Loading...
