GE Voluson i BT06 - Page 351

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-9
8-2-1-5 System Software - Installation Procedure (FMI from DVD) (cont’d)
NOTE: If the currently installed software has to be upgraded to a newer version, and the system DVD being
used is SW 8.2.0 or higher, a new software specific “Permanent key is required.
• Enter the appropriate “Permanent Key”
(calculated in OKOS; http://3.187.187.9/OKOS), select OK and
confirm with ENTER
.
• If the entered Permanent key is correct, following window appears, confirm with ENTER
.
14.)Check disk is performed automatically - restart.
Figure 8-8 insert Permanent Key
Figure 8-9 confirm Permanent Key
Figure 8-10 Check disk is performed automatically
Note: This Example shows
fictional numbers.