SC201(1900A/1903A) Contents
I
Contents
1. General Instruction.......................................................................................................................1
1.1 Specifications of SC201........................................................................................................1
1.2 Corresponding Machine Type...............................................................................................2
1.3 Input Mode............................................................................................................................ 2
1.4 Display Method.....................................................................................................................2
1.5 Arrangement of the Panel......................................................................................................2
1.6 Standardization......................................................................................................................2
1.7 Operation Mode.................................................................................................................... 2
2. Operation Instruction................................................................................................................... 3
2.1 Instructions of the Panel........................................................................................................3
2.2 Installing the Main Motor..................................................................................................... 4
2.3 Test Mode..............................................................................................................................6
2.3.1 CP-1 (Input Signal Check).........................................................................................8
2.3.2 CP-2 (Origin Retrieval)............................................................................................10
2.3.3 CP-3 (Continuous Operation).................................................................................. 10
2.3.4 CP-4 (Revolution Movement)..................................................................................11
2.3.5 CP-6 (Presser and Trimming Motor / Origin Sensor Check).................................. 12
2.3.6 CP-7 (Thread Clamp Motor / Origin Sensor Check)...............................................13
2.4 Operation of the Sewing Machine (Basic)..........................................................................14
2.4.1 Item Data Setting..................................................................................................... 14
2.4.2 Checking the Contour of a Sewing Pattern............................................................. 16
2.4.3 Sewing......................................................................................................................17
2.4.4 Change to Other Sewing Pattern..............................................................................18
2.4.5 Winding a Bobbin.................................................................................................... 18
2.4.6 Thread Clamp Device.............................................................................................. 19
2.4.7 Bobbin Thread Counter............................................................................................21
2.4.8 Temporary Stop........................................................................................................21
2.4.9 Setting the Pattern Thread Tension.......................................................................... 22
2.4.10 Table of the Standard Patterns............................................................................... 22
2.5 Operations of P Pattern and C Pattern................................................................................ 24
2.5.1 Perform Sewing Using the Pattern Key（ ）24
2.5.2 Perform Sewing Using the Combination Function................................................. 28
2.6 How to Use the Memory Switch (User Class)....................................................................31
2.6.1 Start and Change of the Memory Switch.................................................................31
2.6.2 Example of the Memory Switch Setting..................................................................32
2.6.3 Table of Functions of the User Class Memory Switch............................................36
3. Memory Switch (Service Class)................................................................................................. 40
3.1 Start and Change of the Memory Switch (Service Class).................................................. 40
3.2 Table of Functions of the Service Class Memory Switch...................................................40
3.3 Restore Default Setting....................................................................................................... 41
To Next Page
Loading...
