7.缝制图案的选定和确认 Selection and confirmation of the sewing patterns
1) The patterns for eyelet buttonhole bartacking are from No.
11 to No. 13.
2) When the material closing operation is performed, the max-
imum sewing size is 3x7mm. Set the most appropriate size
using the enlargement/reduction function. As for the way of
operation for setting, checking or changing the sewing pattern,
refer to the item "Operation of the sewing machine (basic)"
described in the instruction material for the LK-1900A.
(NOTE) After setting, check the needle entry point whether or
not the needle interferes with the work clamp foot.
1）锁眼加固用的图案为NO.11-NO.13。
2）靠布动作时的最大缝纫尺寸为3*7厘米，请利用扩
大、缩小功能设定为最适的尺寸。
缝制花样的设定、确认、变更的操作方法请参照
LK-1900A使用说明书的缝纫机的操作(基础篇)内容。
（注意）设定后,请一定确认机针是否与压脚相碰,落
针位置是否正确。
※ 缝制尺寸为放大率100%的尺寸。
※ Sewing size is the dimension when the enlargment rate is
100%.
使用专用压脚时，请确认缝制图案的形状。
万一，压脚突出缝制图案，缝制途中机针就有碰到压脚，发生断针的危险。
注意
CAUTION
In case of using an exclusive work clamp foot, make sure of the shape of the Sewing pattern. It the
sewing pattern extends outside the work clamp foot, the needle interferes with the work clamp foot
during sewing, resulting in the danger of the needle breakage or the like.
图案号码
Pauern No.
11
12
13
缝制尺寸
Sewing size (mm)
针数
Number
of stitches
纵
Lengthwise
横
Crosswise
2.5 6
2.5 6
2.5 6
21
28
36
使用说明书 Operation Instruction
66
To Next Page
Loading...
