SC201(1900A/1903A) Operation Instruction
21
2.4.7 Bobbin Thread Counter
2.4.8 Temporary Stop
When memory switch No.31 is set to “1”, key can be used as the temporary stop key.
(1) Sewing machine stops by means of key.
Error 50 is indicated.
(2) There are two operations after stop as below.
Press key to perform thread trimming, perform position with or key,
and re-start by means of the start switch.
Press key to perform thread trimming, and press again key to return to the
origin.
(1) Press key to indicate the Counter
.
(2) Then press the key.
(3) Then press the or key, and set the
specified number of times that can be sewn with a
bobbin.
(4) Every time, the sewing machine finishes a sewing
cycle, counting-down is made by one.
(5) When the sewing machine finishes the specified
number of times, the sewing machine doe not start
even if depressing the pedal.
(6) Replace the bobbin with a new one, and press the
key. The value of the counter returns to the
set value.
(7) Repeat the steps of procedure from the steps (3) to
(5).
To Next Page
Loading...
