SC201(1900A/1903A) Operation Instruction
17
breakage.
2.4.3 Sewing
(1) Set a workpiece on the work clamp foot section.
(2) Depress the pedal switch to the first step, and the
work clamp feet will come down. If you detach
your foot form the pedal switch, the work clamp
feet will go up.
(3) Depress the pedal switch to the second step after
descending the work clamp feet at the first step,
and the sewing machine will start sewing.
(4) After the sewing machine completes sewing, the
work clamp feet will go up, and return to the
sewing start position.
(1) Press the key to make the Ready LED light up.
(2) Select the work clamp foot lowering with
key. Lower the work clamp foot with the foot
switch.
Note: The sewing machine does not start even when
the foot switch is depressed under this mode.
(3) Press key in the state that the work clamp foot
is lowered.
Note: The work clamp foot does not go up even when
the foot switch is detached.
(4) Confirm the contour of the pattern with
or key.
(5) The work clamp foot will go up when is pressed.
(6) Use key to move to other items, then press
key to finish, and the sewing LED goes off.
To Next Page
Loading...
