Gemsy GEM1900A - Page 58

Indication Function Setting range State when delivered Remarks
State of work clamp foot when
machine stopped by temporary
Stop command can be selected.
0:Work clamp foot goes up.
1 :Work clamp foot goes up
with work clamp foot Switch.
2:Lift of work clamp foot is
Prohibited.
0
Needle bar stop position is set. 0:UP position
1:Upperdead point
0
Needle bar rotates in the reverse
Direction after the UP position stop
and stops when upper dead point
stop is set.
Thread trimming can be
Prohibited.
0:Normal
1:Thread trimming prohibited
0
Route of origin return by means
of clear key can be selected.
0:Straight line return
1:Reverse return of pattern
0
This function is used when straight
line return from the midway of
pattern to the start of sewing is not
Possible.
Bobbin winding speed can be
set.
800 to 2,000
16 00
Max. speed limitation has priority.
Operation timing of material
Closing is selected.
LK-190IA only
0:Output prohibited
1:Operation when work clamp
foot comes down.
2:Operation at the time of
Start.
2
For the machines other than LK-
190IA, this function is not
Indicated .
Wiper operation method can be
Selected.
0:Without wiper at the time of
thread trimming on the way
1:With wiper at the time of
thread trimming on the Way ①
2:With wiper at the time of
thread trimming on the Way②
3:Magnet wiper
1
① : Without return of the last wiper
② : With return of the last wiper
Tie stitching at the start of
sewing
Of the pattern for button sewing
can be prohibited. For LK-1900A
Only
0:Tie stitching effective
1:Tie stitching ineffective
0
For the machines other than LK-
1900A, thus function is not
Indicated .
Position of origin moves 5 mm to
The front.
0:Standard
1:Front
0
Necessary to set this function
when using work clamp foot and
Pattem of LK-1904
This function sets whether or
Notthe calling of the pattern data
is Operative.
0:Calling inoperative
1:Calling operative
Setting depends on
the model used
Service pattern Nos. 1 t0 64 can
be individually set.
Grease replenishing time
Information counter
- Refer to the item "Replenishing the
Designated places with grease" of
MAINTENANCE, p.37.。
Register of the pattern is
Performed.
Refer to the item "Performing
Sewing using the pattern keys", P.
24.
Register of the cycle stitching is
Performed.
Refer to the item "Performing
sewing using the combination
Function, P. 27.
使用说明书 Operation Instruction
48