Figure 120: Inbound Route - Multiple Mode
When Multiple Mode is enabled for the inbound route, the user can configure a “Default Destination” and a “Mode 1”
destination for this route. By default, the call coming into this inbound route will be routed to the default destination.
SIP end devices that have registered on the UCM6200 can dial feature code *62 to switch to inbound route “Mode 1”
and dial feature code *61 to switch back to “Default Destination”. Switching between different mode can be easily done
without web UI login.
For example, the customer service hotline destination has to be set to a different IVR after 7PM. The user can dial *62
to switch to “Mode 1” with that IVR set as the destination before off work.
FAX Intelligent Route
The UCM6200 can automatically detect Fax and phone signal coming from the FXO port, and then forward Fax or
phone signal to the right destination. For example, when a regular phone call is coming, the UCM6200 will be able to
detect the phone signal and forward it through the correct inbound route to the destination; if Fax signal is coming, the
UCM6200 will be able to forward it to the FXS extension where the Fax machine is connected.
To Next Page
Loading...
Need help?
General
