UCM6200 Series User Manual
SIP Settings/Session Timer
Table 92: SIP Settings/Session Timer
Select the session timer mode. The default setting is "Accept".
The options are:
Originate
Always request and run session timer.
Accept
Run session timer only when requested by other UA.
Refuse
Do not run session timer.
Configure the maximum session refresh interval (in seconds). The default setting
is 1800.
Configure the minimum session refresh interval (in seconds). The default setting
is 90.
Select the session refresher to be UAC or UAS. The default setting is UAC.
SIP Settings/TCP and TLS
Table 93: SIP Settings/TCP and TLS
Configure to allow incoming TCP connections with the UCM6200. The default
setting is "No".
Configure the IP address for TCP server to bind to. 0.0.0.0 means binding to all
interfaces. The port number is optional. If not specified, 5060 will be used.
Configure to allow incoming TLS connections with the UCM6200. The default
setting is "No".
Configure the IP address for TLS server to bind to. 0.0.0.0 means binding to all
interfaces. The port number is optional. If not specified, 5061 will be used.
Note:
The IP address must match the common name (hostname) in the certificate.
Please do not bind a TLS socket to multiple IP addresses. For details on how to
construct a certificate for SIP, please refer to the following document:
http://tools.ietf.org/html/draft-ietf-sip-domain-certs
Select the TLS protocol for outbound client connections. The default setting is
TLSv1.
If enabled, the TLS server's certificate won't be verified when acting as a client.
The default setting is "Yes".
This is the CA certificate if the TLS server being connected to requires self-signed
certificate, including server's public key. This file will be renamed as "TLS.ca"
automatically.
To Next Page
Loading...
