Grandstream Networks UCM6200 - Alert Log; Figure 214: System Events->Alert Events Lists: System Reboot; Figure 215: System Events->Alert Events Lists: System Crash

P a g e | 308
UCM6200 Series User Manual
Figure 214: System Events->Alert Events Lists: System Reboot
 Detect Cycle: The UCM6200 will check the system reboot based on this cycle. Users can enter the
number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
5. System Crash
Figure 215: System Events->Alert Events Lists: System Crash
 Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
Click on the switch to turn on/off the alert and Email notification for the event. Users could
also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email Notification
On", "Email Notification Off" to control the alert and Email notification configuration.
Alert Log
Under Web GUI->Status->System Events->Alert Log, system messages from triggered system events are
listed as alert logs. The following screenshot shows system crash alert logs.