Grandstream Networks UCM6200 - DHCP Client List; Figure 25: UCM6200 Network Interface Method: Dual; Figure 26: DHCP Client List

P a g e | 55
UCM6200 Series User Manual
Figure 25: UCM6200 Network Interface Method: Dual
DHCP Client List
This feature can bind MAC to IP addresses on the LAN port when UCM6200 is set to Route mode.
When devices receive IP addresses from LAN port, they will be listed on the webUI under “Settings > Network Settings
> DHCP Client List” as shown below.
Figure 26: DHCP Client List
User can bind manually a MAC to an IP address by clicking on , the following
figure will pop up.