The 2nd number indicates the nth iteration of the weekday: (1st Sunday,
3rd Tuesday…). Normally 1, 2, 3, 4 are used. If 5 is used, it means the last
iteration of the weekday.
The 3rd number indicates weekday: 0,1,2,..,6 ( for Sun, Mon, Tues, ...
,Sat).
Therefore, this example is the DST which starts from the First Sunday of
April to the 1st Sunday of November.
Set Time Manually
To manually set the time on the UCM6200, go to Web UI->Settings->Time Settings->Set Time Manually. The
format is YYYY-MM-DD HH:MI:SS.
Figure 59: Set Time Manually
-------------------------------------------------------------------------------------------------------------------------- ------------------
Note:
Manually setup time will take effect immediately after saving and applying change in the web UI. If users would
like to reboot the UCM6200 and keep the manually setup time setting, please make sure "Remote NTP Server",
"Enable DHCP Option 2" and "Enable DHCP Option 42" options under Web GUI->Settings->Time Settings-
>Time Auto Updating page are unchecked or set to empty. Otherwise, time auto updating settings in this page
will take effect after reboot.
-------------------------------------------------------------------------------------------------------------------------- ------------------
Office Time
On the UCM6200, the system administrator can define "office time", which can be used to configure time
condition for extension call forwarding schedule and inbound rule schedule. To configure office time, go to Web
UI->Settings->Time Settings->Office Time. Click on "Create New Office Time" to create an office time.
To Next Page
Loading...
