--------------------------------------------------------------------------------------------------------------- -----------------------------
Note:
ï‚· To configure LDAP sync, please go to UCM6200 web GUI->PBX->Basic/Call Routes->VoIP Trunk. You
will see "Sync LDAP Enable" option. Once enabled, please configure password information for the remote
peer UCM6200 to connect to the local UCM6200. Additional information such as port number, LDAP
outbound rule, LDAP Dialed Prefix will also be required. Both the local UCM6200 and remote UCM6200
need enable LDAP sync option with the same password for successful connection and synchronization.
ï‚· Currently LDAP sync feature only works between two UCM6200s.
ï‚· (Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is non-UCM6200
PBX. However, it might not work the other way around depending on whether the non-UCM6200 PBX
supports event list BLF or remote monitoring feature.
-------------------------------------------------------------------------------------------------------------------------- ------------------
To Next Page
Loading...
Need help?
General
