4-12
Operation
1 Create one data you want to copy.
Cutting data is stored in the buffer memory.
2 Press the POSITION (
) key and move the tool carriage
to the position to copy.
Supplement
When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
If too much data is sent from the buffer
memory, "1 copy in the Copy mode buffer!"
will be displayed.
If the data to be copied is larger than the
cutting area, "Cannot copy, the valid area is
too small" will be displayed.
3 Press the [COPY] key.
COPY MODE screen is displayed.
4 Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE setting screen is displayed.
5 Press the [1] key (OFF).
Confirm the settings and return to the COPY MODE screen.
6 Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
Supplement
Number of copies can be set from 1 to 100,
as much as it can fit in the media set on the
printer.
The initial value for the number of copies is
always 1.
7 Press the POSITION ( ) key and increase or decrease the
setting value.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or
set the media that is big enough to copy.
8 Confirm the setting and press the POSITION ( ) key
(PREVIOUS).
Number of copies will be selected, and it will return to COPY mode
screen.
To Next Page
Loading...
