4-13
Supplement
Copy interval can be set when MEDIA
CHANGE MODE is turned off.
Copy space can be set from 1.0 mm to 10.0
mm.
This setting is maintained even if the power
is turned off.
9 Press the [3] key (COPY SPACE).
COPY SPACE setting screen is displayed.
10 Press the POSITION ( ) key and increase or decrease the
setting value.
11 Confirm the setting and press the POSITION ( ) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY MODE screen.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times
until the buffer memory is cleared. It can be
copied again after exchanging the media by
pressing [COPY] key.
12 Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as
specified.
To Next Page
Loading...
