GRAPHTEC CE6000-120AP - Page 14

C-2
2.3 Loading Media (Paper)..................................................2-7
Loading Roll Media ...................................................2-7
Loading Sheet Media ................................................2-14
2.4 Aligning the Push Rollers...............................................2-16
Aligning the Push Roller ..............................................2-16
When Feeding Long-axis Media (at exceeds 2 meters)............................2-16
When Feeding Long-axis Media (at least 2 meters) ..............................2-17
To use a paper wider than 1,119 mm ..........................................2-17
For minimum width media...................................................2-17
Changing the Hold-down Force ........................................2-18
Switching ...............................................................2-18
2.5 About the Default Screen...............................................2-19
2.6 Connecting to the Power ...............................................2-20
2.7 How to Use Control Panel ..............................................2-21
Control Keys .......................................................2-21
Menu Keys.........................................................2-21
Indicator Lamp......................................................2-22
Reading the Screen (LCD) ............................................2-22
Default Screen (Ready Screen) ..............................................2-22
Contents of Operation from Menu Screen.................................2-24
Simple menu.............................................................2-24
Normal menu ............................................................2-24
Contents of Operation from [COND/TEST] Key ............................2-25
2.8 Setting Feeding Method................................................2-26
2.9 Auto media transfer and cross cut........................................2-28
2.10 Selecting Tool Condition ...............................................2-29
Selecting Tool Condition....................................................2-29
Setting the Tool Condition.............................................2-30
Setting the Tool.....................................................2-31
Setting Condition No.1 (Pen plunger specific) ...................................2-31
Setting for Condition No.2 to No.8 (For cutter plunger) ............................2-32
Setting the Speed ...................................................2-34
Setting the Force....................................................2-35
Setting the Acceleration ..............................................2-36
Adjust the Blade Length ..............................................2-37
2.11 Setting Cut Line Pattern................................................2-38
2.12 Running Cutting Tests .................................................2-41
Cutting Test........................................................2-41
Confirm the Results of the Cutting Test...................................2-42
Adjustment of Offset.......................................................2-42
Adjustment for Cutting Out..................................................2-42
Adjustment When Using Plotting Pen..........................................2-42
2.13 About Simple menu ...................................................2-43
2.13.1 Setting Page Length (Simple mode)......................................... 2-44
2.13.2 Setting the number of pre feeds (Simple menu) ................................ 2-46
2.13.3 User selection settings (Simple menu) ........................................2-47
2.13.4 Setting RS-232C interface (Simple menu) .................................... 2-49
Changing and saving the RS-232C interface settings ............................ 2-49
2.13.5 Display Length Unit Settings (Length Unit) (Simple menu)........................ 2-52